Slip-O-Matic™ Pumps

The Slip-O-Matic ™ Centrifugal Pump

The drive assembly of the Slip-O-Matic™ pump is what we refer to as the bearing assembly and it has no bearings or moving seals exposed to the liquid.  We use this unique assembly to drive several different types of pumping systems.  The original unit was a centrifugal design with a housing and impeller.  A four-leg tower is used to suspend the housing, and the impeller is fastened to the shaft.

Regardless of the shaft size used, the hole in the top of the housing is slightly larger and no bearing or seal is used at this point.  As a result, the pump can be run either in or out of the liquid with no wear or damage to the system.  While this pump is not cheap to build, there is nothing available that compares to its quality and durability.  We back up that claim with a full two year warranty.

Also, since the pump is actually suspended in the slip, the rotating drive assembly creates mixing action in the tank.  And by building different sizes of the same design, the pump can be made to meet the volume needs of various requirements and situations.

This centrifugal Slip-O-Matic™ pump is used on many different models, such as the T60, T100, D75C, BP24 as well as other commercial pumping systems.  This same pump has been used in bulk delivery units that can use either electric, hydraulic or gas engine power.

When you want the best slip pump made, choose the
Slip-O-Matic™ Centrifugal

BP24

The BP24

BP30

The BP30 is identical in to the BP24 just longer.